|
How to Buy
APPROXIMATE ANNUAL HEATING/COOLING COSTS
To use this table:
1. Determine the AFUE/SEER of your current system.
2. From the map dtermine the zone you live in, enter the table and
cross reference your zone with the AFUE/SEER of your current system to
determine your approximate annual heating/cooling costs.
3. Compare your annyal heating/cooling cost to that of a new system
with a highter AFUE/SEER.
4. The difference of these two numbers is your estimated annual
savings.
5. Heating and cooling costs include cycled fan operation. Fan costs
are for continuous fan operation. Subtract from total cost if unit is not
set up this way.
|
| |
Typical 10+ year old system
65% AFUE with 6 SEER |
Standard
92% AFUE
with
12 SEER |
Infinity
94% AFUE
with
12* SEER |
| Zone 1 |
Heating
Cooling
Fan |
$1064
258
358 |
$780
120
320 |
$697
119
36 |
| |
Total |
1680 |
1265 |
852 |
| Zone 2 |
Heating
Cooling
Fan |
880
413
362 |
638
206
316 |
571
191
36 |
| |
|
1655 |
1202 |
798 |
| Zone 3 |
Heating
Cooling
Fan |
697
619
361
|
4997
309
308 |
444
286
36 |
| |
|
1677 |
1177 |
766 |
| Zone 4 |
Heating
Cooling
Fan |
514
877
353 |
355
439
294 |
317
405
35 |
| |
|
1744 |
1175 |
757 |
| Zone 5 |
Heating
Cooling
Fan |
330
1238
334 |
213
619
268 |
190
572
33 |
| |
|
1902 |
1224 |
795 |
| Costs in this table are based on a 50,000 Btuh
design heating requirement using an average fuel rate of $0.625 per therm and a nominal
3-ton air conditioner using an average electric rate of $0.0867 per kilowatt-hour.
*A
variable speed furnace improves air conditioing efficiency, allowing
a
12 SEER system to operate more efficiently as a 13 SEER system due to the
electrical efficiency..
The above calculations
are approximations. A more thorough analysis should be done by your dealer.
|
Tips for Buying the Right Size Air Conditioner
Don't use a contractor who wants to size your unit solely on the square
footage of your house. Contractors should calculate how much cooling a home
needs according to guidelines such as the Air Conditioning Contractors of
America's Manual J. To gather the information necessary, a contractor should
spend about an hour poking around your house, taking measurements in each room
and asking questions. He or she needs to measure floors, ceilings and
walls-including all the windows-and check insulation in the attic, walls, and
crawlspaces. Some other factors that go into the cooling load formula include
indoor and outdoor temperatures, number of occupants, shading, siding, and roof
color.
Insist on getting a copy of the cooling load calculations (or computer
printout). These can be useful in comparing bids from contractors. Question
the contractor if the calculations do not include at least all the items
mentioned above, or if they require an explanation.
Don't be tempted by the lowest bid. Be willing to pay for the time the
contractor must spend to do the job right.
Check for duct leaks. Be sure air flow is not restricted by ducts that
are disconnected, crushed, or too small for the system. Ideally, the contractor
should use diagnostic equipment to find leaks and then fix them with quality
duct sealants (not duct tape). It doesn't make a lot of sense to buy a larger
air conditioner to cool your attic or crawlspace!
Buy a high efficiency unit. Central air conditioners are rated by
SEER, or Seasonal Energy Efficiency Ratio. New air conditioners are required by
federal law to have a SEER of 10 or higher. Even though it will cost more, it is
usually worth it to buy at least a SEER 12 unit because over time that initial
investment will be paid back with energy savings. An easy way to identify SEER
12 and higher-rated units is to look for the EPA Energy Starsm logo. If you are
replacing an existing air conditioner, you must replace the whole unit,
including the inside coil and often the blower fan, to achieve the rated
efficiency.
Install for ease of maintenance. Make sure the inside coil can be
reached for cleaning. The contractor may have to install an access panel,
depending on the model. The coil should be cleaned every two years. The air
filter should be located where it is easy to remove. Check it every month during
the summer, and change or clean it whenever it is dirty.
Place outside unit on north or east side of the house, out of direct
sunlight. Leave plenty of room for free airflow on all sides, and at least
four feet at the top. Keep the area free of debris and shrubbery.
Why an Oversized Air Conditioner Is Bad News
An oversized air conditioner doesn't mean cool comfort for you. It means
higher first costs, higher electricity bills, and a home that's uncomfortable to
be in.
Oversized air conditioners run up your utility bill. An oversized unit
short-cycles (runs for shorter periods of time than it should), and uses more
electricity than a properly sized unit. Air conditioners operate more
efficiently the longer they run continuously, and should be sized so they don't
turn on and off frequently on hot days.
An oversized air conditioner can cover up other problems. Ducts that
are leaky or have constricted air flow, improper refrigerant charge, and dirty
coils and filters can make an air conditioner work much harder than it should.
An oversized unit may be able to put out cold air even when these problems
exist. But these conditions can mean costly breakdowns and the spread of
pollutants into your living space.
Oversized air conditioners cost more to buy and don't last as long.
Don't pay extra for an air conditioner that's too big for your house. The larger
system will cost you hundreds of dollars more and give you fewer years of
service-and bad service besides.
An oversized air conditioner makes your house clammy. A unit that's
too big can't dehumidify the air effectively because it runs for only short
periods at a time. The indoor coil never gets cold enough to do its job of
removing moisture from the air. An oversized unit will leave your home cold and
clammy, especially in humid climates.
Oversized air conditioners are noisy. The bigger the air conditioner
the faster the air rushes through the ducts and grilles. Often the grilles are
not designed for the larger unit, so the noise will get even louder as air tries
to force its way through the small openings. There is no happy medium with an
oversized unit. It delivers noisy blasts of frigid air, then shuts off while
moisture builds. On hot days, it will do this repeatedly, making the home more
and more uncomfortable as the day passes.
There is no happy medium with an oversized unit. It delivers noisy blasts
of frigid air, then shuts off while moisture builds. On hot days, it will do
this repeatedly, making the home more and more uncomfortable as the day passes.
|